Hey guys!

I can't get my UMTS card to run at all. As far as I can tell it is being recognized properly and the kernel supports it out-of-the-box and so on, but I can't see anything about in on NetworkManager and the manual procedure using picocom and adressing the device directly gets me only past entering the SIM code. Is there maybe anything I am doing wrong here? :/

Here's a little bit of info about my system:

Lenovo Thinkpad X200
UMTS card: Ericsson F3507g
Arch Linux Stock Kernel 3.12 (I had 3.11 until yesterday, exactly the same problem)
KDE 4.11.3
NetworkManager 0.9.8.8
kdeplasma-applets-plasma-nm 0.9.3.1
modemmanager 1.0.0

Here's some output that might be useful. Bare with me if it's not what you need, I'm a bloody beginner compared to most of you guys.

lspci:
Code:
00:00.0 Host bridge: Intel Corporation Mobile 4 Series Chipset Memory Controller Hub (rev 07)
00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:02.1 Display controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:03.0 Communication controller: Intel Corporation Mobile 4 Series Chipset MEI Controller (rev 07)
00:19.0 Ethernet controller: Intel Corporation 82567LF Gigabit Network Connection (rev 03)
00:1a.0 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #4 (rev 03)
00:1a.1 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #5 (rev 03)
00:1a.2 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #6 (rev 03)
00:1a.7 USB controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #2 (rev 03)
00:1b.0 Audio device: Intel Corporation 82801I (ICH9 Family) HD Audio Controller (rev 03)
00:1c.0 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 1 (rev 03)
00:1c.1 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 2 (rev 03)
00:1c.3 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 4 (rev 03)
00:1d.0 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #1 (rev 03)
00:1d.1 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #2 (rev 03)
00:1d.2 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #3 (rev 03)
00:1d.7 USB controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #1 (rev 03)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev 93)
00:1f.0 ISA bridge: Intel Corporation ICH9M LPC Interface Controller (rev 03)
00:1f.2 SATA controller: Intel Corporation 82801IBM/IEM (ICH9M/ICH9M-E) 4 port SATA Controller [AHCI mode] (rev 03)
00:1f.3 SMBus: Intel Corporation 82801I (ICH9 Family) SMBus Controller (rev 03)
03:00.0 Network controller: Intel Corporation Ultimate N WiFi Link 5300
lsusb:
Code:
Bus 008 Device 002: ID 0bdb:1900 Ericsson Business Mobile Networks BV F3507g Mobile Broadband Module
Bus 008 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 007 Device 002: ID 17ef:480c Lenovo Integrated Webcam
Bus 007 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
ifconfig
Code:
enp0s25: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        ether f0:de:f1:08:6a:21  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
        device interrupt 20  memory 0xf2600000-f2620000  

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 0  (Local Loopback)
        RX packets 850  bytes 30331 (29.6 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 850  bytes 30331 (29.6 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wls1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.0.16  netmask 255.255.255.0  broadcast 192.168.0.255
        inet6 2a02:8071:2510:b400:221:6aff:febb:aa7a  prefixlen 64  scopeid 0x0<global>
        inet6 fe80::221:6aff:febb:aa7a  prefixlen 64  scopeid 0x20<link>
        ether 00:21:6a:bb:aa:7a  txqueuelen 1000  (Ethernet)
        RX packets 11519  bytes 10882256 (10.3 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 7862  bytes 1221541 (1.1 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
iwconfig
Code:
enp0s25   no wireless extensions.

wwp0s29f7u4i7  no wireless extensions.

lo        no wireless extensions.

wls1      IEEE 802.11abgn  ESSID:"Kann ich dein Klo putzen?"  
          Mode:Managed  Frequency:2.412 GHz  Access Point: 44:32:C8:30:69:DE   
          Bit Rate=72.2 Mb/s   Tx-Power=14 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=21/70  Signal level=-89 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:2717  Invalid misc:128   Missed beacon:0
Thanks in advance for any help or advice given!