problem after processor upgrade

Printable View

10-02-2004, 08:54 PM
brianf191

problem after processor upgrade

The processor on my linux box took a dump, so I got a newer one. Now, linux won't boot. It gets to the point where (I'm assuming) it mounts the cd rom, and reboots. When I try to reinstall linux, it gets to the same point and reboots (booting from cd).

handy information:
I'm using mandrake 9.2
mobo is gigabyte Ga-5aa
processor is AMD K6-2 500 Mhz Old processor was P 233 MMX
256 MB Ram
SiS 6326 video card
Creative 52X CD Rom
I have switched out the cd rom with one I know is good, and had the same problem.

Any Ideas??
10-02-2004, 09:32 PM
janet loves bill

before installing the new processor, you should have re-compiled a new kernel and change the processor type.............
the kernel thinks your using an Intel Pentium when
you actually booted up an AMD.......................way different chips!!!
10-02-2004, 09:41 PM
gehidore

can you use the AMD proc on a Board made for a Pentium?
10-02-2004, 11:45 PM
brianf191

It's a socket 7 motherboard. the old pentiums and K6's used them.

I can't get it to boot even with the install cd.
I didn't know about having to re compile the kernel.
10-03-2004, 01:04 AM
gehidore

Quote:

Originally posted by brianf191
It's a socket 7 motherboard. the old pentiums and K6's used them.

I can't get it to boot even with the install cd.
I didn't know about having to re compile the kernel.

see if you can get a hold on a pentium based proc for that board
if you cant find one, 5$ and i will send you a 100 or 150 which ever i can find...
10-03-2004, 01:38 AM
brianf191

I'm pretty sure I can borrow one from work.

Would that keep it from booting using the install disk?
10-03-2004, 02:04 AM
gehidore

Quote:

Originally posted by brianf191
Would that keep it from booting using the install disk?

im not possitive, but i think that using the amd on the pentium based board would cause problems, although since i have never had a working pentium board, i only have used k6-2 chips on slot 7 boards(all the pentiums i have tried on those board s fried)

also, are you sure that the new processor is supported speed wise by your motherboard?
10-03-2004, 12:30 PM
brianf191

Yes, and I double checked the jumper settings.
I used a windows boot disk, and it booted into dos with out any problems.